Need help?Do you have a question about the AQ Elteknik D72 and is the answer not in the manual?
General| Input Voltage | 24 VDC |
|---|---|
| Output Voltage | 12 VDC |
| Output Current | 6 A |
| Power | 72 W |
| Protection | Overload, Short Circuit |
Product conformity to CE, WEEE, RoHS directives and EN standards.
Warranty terms covering defects in materials/workmanship for one year from purchase.
Usage warnings for sensors and guarantee of passed function/quality tests.
Explanation of the controller's function, its modes, and sensor types.
Instructions for mounting and connecting D72/G72 controllers via DIN-rail.
Instructions for mounting and connecting the DP72 controller via DIN-rail.
Instructions for mounting the D128 controller with IP65 considerations.
How to select sensor mode and interpret the start-screen display.
Step-by-step guide for initial setup, connection, and calibration of the Air Sensor.
Explanation of how the Air Sensor works and how mounting affects performance.
Adjusting sensitivity and filter for optimal bubble detection.
Detailed instructions for wiring the Air Sensor to the controller.
Configuration options for Air Sensor type, diameter, sensitivity, and filter.
Explanation of the information displayed on the Air Sensor mode start-screen.
Advanced settings, mode selection, simulation, and calibration procedure.
How to view measurement data for validation and interpretation of calibration data.
Understanding Ndata and VLdata for different measurement sensitivities.
Unprocessed data, help info, and effect of sound velocity on measurements.
Diagnosing and resolving common problems with the Air Sensor.
Steps for installing, connecting, and setting up the Level Switch.
Explanation of Echo and WR measurement techniques used by the Level Switch.
How to mount the switch and configure its parameters.
Calibration procedures and viewing measurement data.
Resolving common problems with the Level Switch.
Initial setup, connection, and calibration steps for the Level Sensor.
How the Level Sensor works and its physical mounting.
Handling non-level bottoms and mounting velocity sensors.
Understanding the start screen and configuring Level Sensor parameters.
Calibration procedures and viewing measurement data.
Resolving common problems with the Level Sensor.
Initial setup, connection, and calibration for Gel Sensors.
How gel concentration is measured and the techniques used.
Understanding the start screen and configuring Gel Sensor parameters.
Calibrating Gel Sensors and viewing measurement data.
Resolving common problems and understanding reliability.
How to connect via Profibus and configure its parameters.
Interpreting status symbols and understanding data exchange.
Diagnosing and resolving Profibus communication issues.
To Next Page