EasyManuals Logo

Aqua Computer aquaero 5 User Manual

Aqua Computer aquaero 5
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
AQUAERO 5 / AQUAERO 6
ple be configured to cease function upon alarm events and thereby relay the
alarm status to a fan connector of your motherboard. Functionality of the speed
signal can be configured using the menu entries “Alarm” and “Timer”. For details
on how to configure your motherboard to process the speed signal, please refer to
the manual of your motherboard.
Compatible products:
aquabus / speed signal cable 3 pin (article no. 93111/53161)
4.8.
4.8.4.8.
4.8. Connector “Sensors”
Connector “Sensors”Connector “Sensors”
Connector “Sensors”
Connector for up to 8 temperature sensors.
Pin assignment: Pin 1/2: Sensor 1
Pin 3/4: Sensor 2
Pin 5/6: Sensor 3
Pin 7/8: Sensor 4
Pin 9/10: Sensor 5
Pin 11/12: Sensor 6
Pin 13/14: Sensor 7
Pin 15/16: Sensor 8
Compatible sensors:
Temperature sensor inline G1/4 (53066)
Temperature sensor inner/outer thread G1/4 (53067)
Temperature sensor G1/4 (53147)
Temperature sensor plug&cool (53025)
Temperature sensor 70 cm (53026)
4.9.
4.9.4.9.
4.9. Connector “USB”
Connector “USB”Connector “USB”
Connector “USB”
This connector is used for USB communication to the PC and for standby power
supply. Take special care to make sure the pin alignment matches your mother-
board!
Pin assignment: Pin 1 +5 V (red)
Pin 2 D- (white)
Pin 3 D+ (green)
Pin 4 GND (black)
Pin 5 not connected
4.10.
4.10.4.10.
4.10. Connectors “Flow 1” and “Flow 2”
Connectors “Flow 1” and “Flow 2”Connectors “Flow 1” and “Flow 2”
Connectors “Flow 1” and “Flow 2”
Connectors for flow sensors. Use sensors and cables specified by Aqua Computer
only!
Please note:
Please note:Please note:
Please note: The Flow 2” connector may also be labeled as “aquabus low” on
the device. The function of this header is determined solely
by the current firmware
version of the aquaero. Starting with firmware version “2010”, this header can be
connected to a flow sensor irrespective of connector labeling.
- 10 - Aqua Computer GmbH & Co. KG © 2014-2019
Gelliehäuser Str. 1, 37130 Gleichen
c
o
m
p
u
t
e
r
a
q
u
a

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Aqua Computer aquaero 5 and is the answer not in the manual?

Aqua Computer aquaero 5 Specifications

General IconGeneral
BrandAqua Computer
Modelaquaero 5
CategoryController
LanguageEnglish

Related product manuals