15
UK
Ensuring the filtered rubber inlet washers are positioned within
the valve inlets, oer the valve into position. Tighten the fixing
nuts using a suitable tool taking care not to over tighten.
We recommend the rubber filter washers should be used.
Ensuring the hose washer is in place, attach the hose to the valve
hose outlet to allow the water to discharge safely to waste.
Turn on the supplies to the shower and turn the shower on to
flush the system through. Turn o the shower.
Image shows 220 shower valve
Image shows 220 shower valve
Place the cover plates onto the exposed ¾” threads, flush with the
finished wall surface and apply a thin bead of mastic if required.
The cover plate may vary from the image shown.
Image shows 220 cover plates
5
6
7
To Next Page
