10-02-2020 Page 21 of 32 ARB Copyright 2017 3789736
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
5.10) Splice the convoluted tube exiting the cabin to the
main tube as shown in the diagram. Tape the
splice to prevent dust entering.
GO BACK AND CABLE TIE THE CONVOLUTED
TUBE EVERY 300mm.
Continue routing the convoluted tube with the dual
core wire down to the front of the vehicle avoiding
any sharp hot or moving objects. Cable tie every
300mm.
5.11) At the battery fit the Scotch Lock Blade Fuse
Holder to positive (RED) wire and fit to the positive
battery terminal. Fit the negative (BLACK) wire to
the negative battery terminal.
Fit the Blade Fuse and TEST ALL LIGHTS.
5.12) Remove tail light assembly right hand side. Do this
by first undoing the 2 screws in the tailgate
opening. Then push the light to the side.
To Next Page
Loading...
