Tips:
1. Daily checking is very important in keeping the high performance and safe operation
of this cutting machine.
2. Do daily checking according to the table below, and clean or replace components
when necessary.
3. In order to ensure the high performance of the machine, please choose components
provided or recommended by dealer when replacing components.
4.
Daily checking of the cutting machine
Whether any of the components are damaged or loosely
connected;
Whether the output quick sockets are tightened;
Whether the abnormity indicator illuminates.
If unqualified,
check the
interior of the
machine, and
tighten or
replace the
components.
Whether the input power cable and buckle are in good
condition;
Whether the air intake is unobstructed.
Whether the bolts are loosely connected.
If unqualified,
tighten or
replace the
components.
Whether the side plate is loosely fixed.
Whether the screws are loosely connected.
Whether the machine enclosure has color fading or
overheating problems;
Whether the fan sounds normal when the machine is
running;
Whether there is abnormal smell, abnormal vibration or
noise when the machine is running.
If abnormal,
check the
interior of the
machine.
Daily checking of the cables
Whether the grounding wires (including workpiece
GND wire and cutting machine GND wire) break off.
If unqualified,
tighten or replace
the components.
Whether the insulating layer of the cable is worn, or
the conductive part of the cable is exposed;
Whether the cable is drawn by an external force;
Whether the cable connected to the workpiece is well
connected.
Use appropriate
methods according
to the work site
situation to ensure
safety and normal
cutting.
To Next Page
