ARCCAPTAIN 55 Pro - Technical Parameters

4
starting. With this mode, the torch head doesn't require contact with the metal plate,
extending the lifespan of consumables and allowing for increased cutting thickness.
Additionally, plasma cutters with this function can cut through steel plates with rust and
paint on the surface.
 Multi-scene cutting
The CUT55 is a versatile plasma cutter that can be used with either 120V or 240V AC
voltage. It operates using compressed air as the plasma gas source for cutting metals, so
ensure your air compressor is ready for use. The unit is designed to cut up to 3/5” inch
mild steel, but has the capability to cut other metals such as stainless steel, copper, cast
iron, and aluminum. With its simple operation and high cutting speed, it delivers smooth
cutting surfaces without requiring additional polishing.
 Smart postflow
The gas will continue to flow for a little while
of postflow, The postflow will adjust to the
most suitable time based on the current size(0-5s), reduce unnecessary adjustment
operations.
2.2 Technical parameters
Items
Models
CUT55
Rated input power supply
Single-phase AC240V
50/60Hz
Single-phase AC120V
50/60Hz
Rated input capacity (kVA)
9.4
5.5
Power factor
0.7
Rated output (A/V)
55/102
35/94
Rated duty cycle (%)
60
No-load voltage (V)
330V
Output current range (A)
20~55
20~35
Arc ignition mode
HF contact
Post-flow time (s)
5
Gas pressure range (Mpa/PSI)
0.2~0.5Mpa
29~72psi
Insulation grade
H
Cooling mode
Air cooling
Enclosure ingress protection
IP21S
Efficiency (%)
85