arcelik 6233 - Page 48

46 Dishwasher / User’s Manual/48 EN
Troubleshooting
• Cutleryaremadeoflowqualitystainlesssteel.>>>Corrosiononsuchitems
is inevitable; they should not be washed in dishwashers.
• Kitchenutensilsthatarealreadycorrodedarewashedindishwasher.>>>
Rust on a corroded item can migrate to other stainless steel surfaces and
cause corrosion on those surfaces as well. Such items should not be washed
in dishwashers.
Detergent remains in detergent dispenser.
• Detergentdispenserwasdampwhenaddingdetergent.>>>Makesurethat
the detergent dispenser is dried well prior to filling it with detergent.
• Detergentisaddedlongbeforethewashingprocess.>>>Payattentionto
add detergent shortly before start-up of the washing.
• Openingofthedetergentdispenserlidispreventedduringwashing.>>>
Place the dishes in a way that will not prevent the detergent dispenser lid from
opening and the water going into the machine from impellers.
• Detergentisstoredunderunsuitableconditions.>>>Ifyouareusingpowder
detergent, do not store the detergent package in humid places. Keep it in a
closed container if possible. For ease-of-storing, we recommend you to use
tablet detergents.
• Impellerholesareclogged.>>>Lowerandupperimpellerholesmightbe
clogged with food remnants such as lemon pips. Clean the impellers regularly
as illustrated in section “Cleaning and Care”.
Decorations and ornaments on kitchen utensils are being erased.
C
Decorated glasses and decorated lustre porcelains are not suitable
for washing in the dishwasher. Manufacturers of some glassware and
porcelain tableware items do not recommend washing such kitchen
utensils in the dishwashers either.
Dishes are scratched.
C
Kitchen utensils that contains or are made of aluminum should not be
washed in dishwasher.
• Saltleakageexists.>>>Payattentionnottospillsaltaroundthesaltfilling
hole while adding salt. Spilled salt can cause scratches. Make sure that the
salt reservoir lid is tightly closed after finishing the filling process. Run the
prewash programme to remove the salt that spilled inside the machine. Since
the salt granules that will remain under the lid will dissolve during prewash,
causing the lid loosen, check the lid once again at the end of the programme.
• Waterhardnesssettingisloworsaltlevelisinsufficient>>>Measurethe
hardness of the supply water appropriately and check the water hardness
setting.