arcelik 6233 - Page 49

Dishwasher / User’s Manual
47 / 48
EN
Troubleshooting
• Dishesarenotplacedorderlyinthemachine.>>>Whenplacingtheglasses
and other glassware into the basket lean them not against other dishes but
the edges or racks of the basket or the glass support tines. Striking of the
glasses to each other or to other dishes due to the impact of water during
washing can cause breaks, or scratches on their surfaces.
A smear remains on glasses that resembles milk stain which can not be
removed when wiped by hand. A bluish / rainbow appearance occurs
when the glass is pointed to light.
• Excessiverinseaidisused.>>>Lowerrinseaidsetting.Cleanthespilled
rinse aid when adding rinse aid.
• Corrosionhasoccurredonglassduetosoftwater.>>>Measurethehardness
of the supply water appropriately and check the water hardness setting. If
your supply water is soft (<5 dH), do not use salt. Choose programmes that
wash in higher temperatures (e.g. 60-65°C). You can also use glass protective
detergents that are commercially available.
Foam forms in the machine.
• Dishesarewashedwithhand-washdetergentbyhandbutnotrinsedbefore
placingthemintothemachine.>>>Hand-washdetergentsdonotcontain
antifoam. There is no need to hand-wash the dishes before placing them into
the machine. Removing the coarse soil on the dishes under tap water, with a
tissue paper or fork will be sufficient.
• Rinseaidhasspilledintothemachinewhenaddingrinseaid.>>>Takecare
that rinse aid is not spilled in the machine when you are filling it. Clean any
spilled rinse ait with the help of a tissue paper/towel.
• Lidoftherinseaidreservoirisleftopen.>>>Makesurethatthelidofthe
rinse aid reservoir is closed after adding rinse aid.
Kitchen utensils are broken.
• Dishesarenotplacedorderlyinthemachine.>>>Loadthedishesas
described in the user manual.
• Basketsareoverloaded.>>>Donotoverloadthebasketsinexcessoftheir
capacity.
Water remains in the dishwasher at the end of the programme.
• Filtersareclogged.>>>Checkifthefiltersystemisclean.Cleanthefilter
system regularly as illustrated in section “Cleaning and Care”.
• Dischargehoseisclogged/blocked.>>>Checkthedischargehose.If
necessary, remove the discharge hose, clear the blockage and insert is as
illustrated in the user manual.
C
If you cannot eliminate the problem although you follow the instructions
in this section, consult your dealer or the Authorised Service Agent.
Never try to repair a nonfunctional product yourself.