Arcom RC-210 - Port Configuration and Operation

7
Default Commands Accessible When Unlocked
Receiver Enable/Disable
Each port's receiver may be temporarily disabled individually to prevent a signal from that receiver from being recognized. Note that this
setting is not stored in non-volatile memory and upon a controller reset or power up, all receivers will once again be enabled.
1101 Port 1 Receiver Enable* 2101 Port 2 Receiver Enable* 3101 Port 3 Receiver Enable*
1100 Port 1 Receiver Disable 2100 Port 2 Receiver Disable 3100 Port 3 Receiver Disable
Transmitter Enable/Disable
Each port's transmitter may be disabled individually to prevent keying by itself or other ports. This command completely disables the
transmitter on that port, except for ID's
1111 Port 1 Enable* 2111 Port 2 Enable* 3111 Port 3 Enable*
1110 Port 1 Disable 2110 Port 2 Disable 3110 Port 3 Disable
Carrier/CTCSS Access
Each port supports an external CTCSS (or digital) decoder, the action of which may be controlled with these commands.
1121 Port 1 CTCSS 2121 Port 2 CTCSS * 3121 Port 3 CTCSS
1120 Port 1 Carrier* 2120 Port 2 Carrier* 3120 Port 3 Carrier*
TouchTone© Covertone
Whenever a DTMF digit is pressed, the receiver audio from that port is muted. Optionally, a covertone may be selected so users aren't
faced with "dead air".
1131 Port 1 Touchtone© 2131 Port 2 Touchtone© 3131 Port 3 Touchtone©
Covertone ON* Covertone ON* Covertone ON*
1130 Port 1 Touchtone© 2130 Port 2 Touchtone© 3130 Port 3 Touchtone©
Covertone OFF Covertone OFF Covertone OFF
Courtesy Tone Selection
Each port has 10 programmable courtesy tone sets.
1134x Port 1 Courtesy Tone 2134x Port 2 Courtesy Tone 3134x Port 3 Courtesy Tone
Select x = 1-10 (1*) Select x = 1-10 (1*) Select x = 1-10 (1*)
Kerchunk Filtering
Each port has its own filtering command to prevent users from "kerchunking" that port. When turned on, these filters require that users
key up for a period of at least the setting of the Kerchunk Timer before the RC-210 will recognize it as a valid signal.
1151 Port 1 Kerchunk Filter On 2151 Port 2 Kerchunk Filter On 3151 Port 3 Kerchunk Filter On
1150 Port 1 Kerchunk Filter Off* 2150 Port 2 Kerchunk Filter Off* 3150 Port 3 Kerchunk Filter Off*