50
Appendix A
Frequency Agile Radios Supported (Firmware Version 4.1)
Kenwood - All model radios with a computer port to allow control of radio.
Kenwood - mobiles such as TM-V7A, TM-G707 and handhelds, such as TH-F6A, TH-G71
Elecraft = All models with a computer port
Yaesu - FT-817, FT-847, FT100D
Icom - IC706MKIIg, IC-746
Doug Hall RBI-1 Remote Base Radio Interface
Factory Default Programming Values
When you first receive your RC-210, the following values are programmed as default:
Port Specific
Carrier/PL Access Carrier squelch All Ports
Hang time Port 1 - 5 seconds. Ports 2 & 3 - 3 seconds
Timeout 180 seconds All Ports
Cw Tone Port 1 - 600 hz. Ports 2 & 3 - 800 hz
CW Speed 20 wpm All Ports
Monitor Mix Yes All Ports
Port Enabled Yes All Ports
Intertie to other ports OFF All Ports
Full / Half Duplex Port 1 - Full duplex, Ports 2 & 3 - Half duplex
Port Enabled Yes All Ports
Receiver Enabled Yes All Ports
DTMF Covertone ON All Ports
Courtesy Tone # 1 All Ports
DTMF Mute ON All Ports
Speech Override ON All Ports
Speech ID Override ON All Ports
ID Aborts ON All Ports
Control Receiver OFF
Global
Logic Output 1 - 7 Open
Alarm 1 - 5 Disabled
Auxiliary Audio Inputs OFF
Analog Meter Inputs None defined
Macros None programmed
Macro Recall Codes 10901 - 109090
Remote Base Type Non-DTMF Kenwood (serial port type)
Remote DTMF Port 3
Fan Turn Off Time 5 minutes
Remote Base Prefix A7
Lock Code #
DTMF Terminator D
Say Year ON
RTC Correction Factor None
To Next Page
Loading...
