153
2. Connect the red MaxiClip and meter lead to the
black/white servo terminal; then connect the black
MaxiClip and meter lead to the yellow servo termi-
nal.
3. Rotate the servo clutch counterclockwise. The ohms
should increase as the clutch is rotated until it
reaches 4700-5000 ohms.
4. Continue the clutch rotation, and there will be a
small area in the rotation where the ohm reading will
disappear; then it will return again.
5. Continue the clutch rotation, and the ohms should
appear at a very low value but will again increase to
4700-5000 ohms. This is normal operation.
FZ088A
6. Install the servomotor.
NOTE: If the servo operates correctly and the
potentiometer test is correct but fails to operate when
connected to the ECM/regulator/rectifier at the desig-
nated RPM, see Troubleshooting Servomotor chart in
this section.
To Next Page
Loading...
