207
ZR-003
8. With shock oil around the seals in the bearing cap
and on the shock rod, slowly compress the shock rod
until the shock eyelet bottoms out. Pressurize the
shock with nitrogen to 200 psi and until the shock
eyelet fully extends.
ZR-018
9. Install the screw into the shock body.
ZR-004
10. Compress the shock eyelet until it bottoms out; then
the shock eyelet should fully extended. Wash the
shock and install the spring.
INSTALLING
1. Place the shock into position on the snowmobile.
2. Secure with existing hardware and bushings.
To Next Page
