72
FC080
42. Secure the starter pulley to the flywheel with three
cap screws and using the spanner wrench, tighten the
cap screws evenly to 19 ft-lb; then tighten the fly-
wheel cap screw (from step 41) to 50 ft-lb.
FC081
43. Install the coolant supply hose to the water pump and
cylinder hose; then install the overflow hose and
secure with the clamps.
44. Install the exhaust manifold using new gaskets and
the existing flange nuts. Tighten to 17 ft-lb.
To Next Page
Loading...
