A. Add sanitizers until levels are up to the recommended levels
B. Replace test kits at least once a year
C. Chlorine/Bromine level very high and is bleaching test reagent, Allow sanitizer levels to recede
by opening cover and running jets.
A. Add Arctic Pure
®
Adjust Up until level reads 7.2 - 7.6 ppm
B. Add Arctic Pure
®
Refresh, add Boost or Peak Boost.
C. Change from Bromine to Chlorine or vice versa.
D. Drain and rell spa.
A. Check pH and adjust as required.
B. Shock with Arctic Pure
®
Refresh, add Boost or Peak Boost dependent on whether you have a
chlorine or bromine system
C. Dilution of water will reduce contaminants and odor.
D. Check any ozone system is operational
A. Drain partially, add Arctic Pure
®
Best Defence, correct pH level to 7.2 - 7.6 and alkalinity to 100-
130 ppm.
A. Shock treatment with Arctic Pure
®
Refresh.
A. High concentration of oils and organics being agitated by the jets and/or
Therapy Air
A. Use Arctic Pure
®
Best Defence and have your dealer check your water balance
B. Add Arctic Pure
®
Boost treatment to raise chlorine levels and test chlorine levels or for Bromine
system add Peak Boost & test Bromine levels
C. Stop the use of fragrance
A. Dirty lter, clean with Arctic Pure
®
Filter Restore (not with disposable lter). Increase Filter
cycle or increase ltration times via the topside control or App.
B. Add Arctic Pure
®
Easy Clear
C. Shock treatment with Arctic Pure
®
Refresh
D. Add Arctic Pure
®
Adjust Down until level reads 7.2-7.6
E. Add Arctic Pure
®
Adjust Down to adjust TA level to 80-120 ppm
F. Shock treatment until combined chlorine is eliminated (see container instructions)
G. Empty spa and rell
H. Add Arctic Pure
®
Best Defence until level reads 100-280 ppm
SOLUTIONS
30
To Next Page
Loading...