Spa Boy Owners Manual
1.14.6 Arctic Spas Spa Boy Salt Dose Guidance Table
The following table identifies the dosage of Arctic Pure Sea Salt Blend that is required for each Arctic Spa model and estimated impact of
adding 225g of salt. Use this table for Spa Boy Version 1 R1.
Operating at the desired salt concentration will reduce potential corrosion and increase the life of the Spa Boy Output Electrode.
Arctic Spas - Spa Boy Version 1 R1 Salt Dosage Chart
Note: The above table provides a guideline to achieve a salinity level of 2200 ppm. Due to differing
levels of compounds and chemicals in water in different suburbs and countries, please ensure you confirm
salinity level is in the desired salinity range using Aquacheck Salt Test Strips
Spa Model Litres US Gal Kg Lb 225 Grams 1/2 lb
Fox 884 234 2.0 4.4 295 ppm 295 ppm
Glacier 1144 302 2.6 5.6 216ppm 216ppm
Glacier Xl 1300 343 3.0 6.6 190ppm 190ppm
Cub 1185 313 2.6 5.6 210ppm 210ppm
Klondiker 1431 378 3.2 7.1 173ppm 173ppm
Frontier 1330 351 3.0 6.6 188ppm 188ppm
Summit 1405 371 3.2 6.9 175ppm 175ppm
Summit XL 1988 525 4.5 10 122ppm 122ppm
Yukon 1360 359 3.1 6.7 180ppm 180ppm
Kodiak 1592 420 3.6 7.8 157ppm 157ppm
Norwegian 1565 413 3.5 7.7 157ppm 157ppm
Tundra 1700 449 3.8 8.4 147ppm 147ppm
Swim Spa (AWP) 5100 1347 11.4 25.1 49ppm 49ppm
Water Volume Metered Fill Point
(Approximately Bottom of Head Rest)
Required Salt Dosage to Achieve 2200ppm
(Salinity Range for Spa Boy Version 1 R1 must
be between 2000 ppm - 25000 ppm)
Estimated Impact of Adding Extra Salt
1.14.7 Sanitizer and pH Readings
The following provides guidance on the establishment and maintenance of sanitizer and pH readings.
Sanitizer Readings
You should have ORP sanitizer (Chlorine) readings within 24 hours.
24 hours post adding the salt to the spas water, My Arctic Spa will be able to provide accurate readings regarding the ORP sanitizer
(chlorine) reading, and pH reading.
Important: Always check the pH and ORP (sanitizer) levels before each spa use.
If the pH reading is out of range (to high), adjust accordingly with Arctic Pure, Salt Water Balance
* Expect the pH too increase slowly over each week and when the pH gets too high use Arctic Pure, Salt Water Balance to correct it.
High pH will cause premature failure of the Spa Boy Output Electrode, cloudy water, and decreased effectiveness of the sanitizer.
69
To Next Page
Loading...
Need help?
General
