Name: Arctic Spas Cub
Brand: Arctic Spas
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Spa Boy Owners Manual

1.14.2 Fill Spa With Water Power Up Spa and Set Water Temperature

The following steps provide guidance to help establish correct chemically balanced water. To help ensure chemicals dissolve appropri-

ately it is good practice to ﬁrst mix/dissolve the chemical in an uncontaminated container of hot water before carefully adding to the

spa water

Note: The following steps take into account that the Spa Technician has ﬁlled your spa with water to above the Spa Boy Sensor Hous

ing, removed the Spa Boy Sensor Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor.

arning: Do not proceed until the Spa Technician has ﬁlled your spa with water to above the Spa Boy Sensor Housing, removed the

Spa Boy Housing Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor. or you have obtained further

direction from your Dealer.

Steps to Fill Spa With Water Power Up Spa and Set Water Temperature

STEP 1. FILL SPA

Fill your spa through the ﬁlter intake as shown to the appropriate level (just under the

head rests). If you have sediment or high mineral content a “carbon ﬁlled pre-ﬁlter”,

as pictured, can help. (This is optional and will prolong the ﬁll time).

STEP 2. CONNECT/TURN ON ELECTRICAL POWER TO THE SP

Once the spa is ﬁlled to the proper level, connect power to the spa in accordance with

the Arctic Spas Owners Manual (Pg 10), and turn the power on to the spa on.

Spa Boy Owners Manual

Spa Boy Owners Manual Version 1 Revision 1 (R1)

Page 14 of 35 Issued 20 Nov 2014

1.14.2 Fill Spa With Water Power Up Spa and Set Water

mperature

The following steps provide guidance to help establish correct chemically balanced water.

To help ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the

chemical in an uncontaminated container of hot water before carefully adding to the spa

water.

Note: The following steps take into account that the Spa Technician has filled your spa

with water to above the Spa Boy Sensor Housing, removed the Spa Boy Sensor Plug,

installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor.

Warning: Do not proceed until the Spa Technician has filled your spa with water

to above the Spa Boy Sensor Housing, removed the Spa Boy Housing

Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa

Boy Sensor. or you have obtained further direction from your Dealer.

Steps to Fill Spa With Water Power Up Spa and Set Water Temperature

Step 1. Fill Spa

Fill your spa through the filter intake as shown to the

appropriate level (just under the head rests). If you have

sediment or high mineral content a “carbon filled pre-filter”,

as pictured, can help. (This is optional and will prolong

the fill time).

Step 2. Connect/Turn on Electrical Power to the Spa

Once the spa is filled to the proper level, connect power to

the spa in accordance with the Arctic Spas Owners Manual,

and turn the power on to the spa on.