Steps to help Set Filtration & Onzen Settings Continued
Step 6. Filter Duration
Press your Filter/Pump 5 button again.
Your display will now show the settings for your Filter Duration.
Step 7. Setting Filter Duration
Use your arrow keys to select your Filter Duration in
hours.
You can select from 0 to 6 hours, the number of hours your filtration
will run each time.
Step 8. Filter Cycle Frequency
Press your Filter/Pump 5 button again.
Your display will now show the settings for your Filter Cycle
Frequency.
Step 9. Setting Filter Cycle Frequency
Use your arrow keys to select your Filter Cycle
Frequency
You can select from 1 to 4 times per day.
You can move backwards through the settings by pressing the Pump 3 button (Pump 4 on Epic series spas). The Pump 1
button will allow you to exit without saving any changes. When you get to the end of the options, press the filter key one last
time to save changes and begin a filter cycle immediately. If you do not press the filter key again your changes will be saved
and the filter cycle will begin when you have programmed it to do so.
* Press your Filter/Pump 5 button again to start the next cycles immediately (Pumps will purge for 20
seconds).
To EXIT without saving changes press Pump 1.
To SAVE & EXIT but not start the cycle simply let the display time out.
5
5
5
Onzen Owners Manual
94
To Next Page
Loading...
Need help?
General
