Arctic Spas Kodiak User Manual

Owners Manual - Expedition Class
12
9) Test and Adjust Sanitizer level (Chlorine ideal 1 - 3 ppm or Bromine ideal 3 - 5 ppm).
10) Rotate diverters to centre position and press “Pump 2” button on topside control panel for 5
seconds to activate the “Boost ltration system”. When this system is enabled, “boo”
is displayed on the screen. This will give 45 min of circulation and ltration to disperse the
chemicals.
11) You can set the temperature (between 38°C and 40°C or 100°F to 104°F) by pressing
the TEMP ( ) and TEMP ( ) buttons on the control panel. The spa will normally
come up to temperature within 16 to 24 hours. Replace the spa cover while the tem
perature is reaching the set point.
IMPORTANT: For safety, you can lock your desired temperature setting.
Refer to the Topside Control Panel section for details.
CAUTION!
Do Not turn on
power to the spa
untilthespaislled
to the required
level. Running the
spa pump without
water could cause
immediate damage
and void your
warranty!
CAUTION!
If your spa or AWP is equipped with Spa Boy or
ONZEN please consult the: Spa Boy Owners
Manual or ONZEN User Guide for further setup
requirements.

Arctic Spas Kodiak Specifications

General

Brand	Arctic Spas
Model	Kodiak
Category	Hot Tub
Language	English