1.11.6 Program Filtration & Onzen Settings
The Onzen Chlorine Production (Onzen Cycle Duration) settings need to be programmed: The following
steps provide guidance on how to program the Onzen system settings:
Steps to help Set Filtration & Onzen Settings
Step 1. Enter Filtration Options Through Topside Controller
Press the Filter button (pump 5 on epics) to enter into
your filtration options. Your display will show “SETT” and from here
you will be able to choose your settings.
Step 2. Ozone Cycle Duration Through Topside Controller
Press your Filter/Pump 5 button again to display your
first option. This is your Ozone Cycle Duration.
* Peak II only, if Peak 1 is installed ozone will run during filtration.
Step 3. Setting Ozone Duration Through Topside Controller
Use your arrow keys o select your Ozone Cycle
Duration. You can select from 1 to 24 hours per day.
Step 4. Enter Onzen Settings Through Topside Controller
Press your Filter/Pump 5 button again until you see
0n02.
Your display will now show the settings for your Onzen system.
Step 5. Onzen Cycle Duration
Use your arrow keys to select your Onzen Cycle Dura-
tion.
You can select from 1 to 24 hours per day.
* Cycles are divided into 4 ie: If 8 hours is selected, the system will
perform 4 x 2 hour cycles per day.
5
5
5
Onzen Owners Manual
93
To Next Page
Loading...
Need help?
General
