Spa Boy Owners Manual
STEP 3. SET WATER TEMPERATURE
Set the water temperature control on the Topside Controller to the desired
temperature (between 100ºF and 104ºF or 38°C and 40°C).
Spa Boy Owners Manual
Version 1 Revision 1 (R1) Spa Boy Owners Manual
Issued 20 Nov 2014
Page 15 of 35
Steps to Fill Spa With Water Power Up Spa and Set Water Temperature
Step 3. Set Water Temperature
Set the water temperature control on the Topside Controller to
the desired temperature (between 100ºF and 104ºF or 38°C
and 40°C).
1.14.3 Program Filtration Cycles/Filtration Duration
The factory default filtration settings will automatically perform 4 x two-hour filtration cycles per day, 6 hours apart. Depending of
bather load and spa usage it is suggested filtration settings can be changed to automatically perform 4 one- hour filtration cycl
es per
day, 6 hours apart.
The system factory filtration settings can be adjusted by the consumer through:
• OnSpa power management using your device such as smart phone or tablet that has been connected to
your spa through WiFi. Refer OnSpa user Guide. (Pg.33)
•
The topside controller low level programing. Refer Arctic Spas Quick Reference Card or Arctic Spas Owners Manual. (Pg.43)
1.14.4 Stabilize Spa Water
Before you attempt to balance the water, the water temperature must first reach a minimum temperature of 85°F, (29°C).
Note: Do not be tempted to use your spa at this time.
Step 1. Stabilize Spa Water
Once the spa has been filled with water, powered up and filtration
requirements set, place the insulated cover on the spa and allow
the water temperature to stabilize
(approximately 16 hours).
Make sure you secure the cover in place using the cover locks.
Periodically check the spa water temperature.
When the water temperature climbs above 85°F, (29°C) proceed
to the next step.
Note: As heat impacts both Calcium and Total Alkalin
-
ity a little, it is highly recommended to heat the water
above 29°C (85°F) before advancing to Establishing
Correct W
ater Chemistry.
Step to Stabilize Spa Water
65
To Next Page
Loading...
Need help?
General
