Arctic Spas Kodiak User Manual

A. Add sanitizers until levels are up to the recommended levels
B. Replace test kits at least once a year
C. Chlorine/Bromine level very high and is bleaching test reagent, Allow sanitizer levels to recede
by opening cover and running jets.
A. Add Arctic Pure
®
Adjust Up until level reads 7.2 - 7.6 ppm
B. Add Arctic Pure
®
Refresh, add Boost or Peak Boost.
C. Change from Bromine to Chlorine or vice versa.
D. Drain and rell spa.
A. Check pH and adjust as required.
B. Shock with Arctic Pure
®
Refresh, add Boost or Peak Boost dependent on whether you have a
chlorine or bromine system
C. Dilution of water will reduce contaminants and odor.
D. Check any ozone system is operational
A. Drain partially, add Arctic Pure
®
Best Defence, correct pH level to 7.2 - 7.6 and alkalinity to 100-
130 ppm.
A. Shock treatment with Arctic Pure
®
Refresh.
A. High concentration of oils and organics being agitated by the jets and/or
Therapy Air
A. Use Arctic Pure
®
Best Defence and have your dealer check your water balance
B. Add Arctic Pure
®
Boost treatment to raise chlorine levels and test chlorine levels or for Bromine
system add Peak Boost & test Bromine levels
C. Stop the use of fragrance
A. Dirty lter, clean with Arctic Pure
®
Filter Restore (not with disposable lter). Increase Filter
cycle or increase ltration times via the topside control or App.
B. Add Arctic Pure
®
Easy Clear
C. Shock treatment with Arctic Pure
®
Refresh
D. Add Arctic Pure
®
Adjust Down until level reads 7.2-7.6
E. Add Arctic Pure
®
Adjust Down to adjust TA level to 80-120 ppm
F. Shock treatment until combined chlorine is eliminated (see container instructions)
G. Empty spa and rell
H. Add Arctic Pure
®
Best Defence until level reads 100-280 ppm
SOLUTIONS
30

Arctic Spas Kodiak Specifications

General

Brand	Arctic Spas
Model	Kodiak
Category	Hot Tub
Language	English