PECA 30 / 30 E : programming-configuration
28
ARDETEM
PULSE OUTPUT OPERATING MODE:
For a « PULS » type board : there are 3 pulses outputs (Nr 1 to 3) by insulated relay contacts.
For an « AnA.P » mixed type board : there are 2 pulses outputs by insulated relay contacts (Nr 4 and 5, the
outputs 1,2 and 3 of the board are current outputs).
For those 2 board types, the programming is nevertheless.
The pulse output correspond to :
- an energy
- an energy increase witch provide a pulse (pulse weight)
3 pulse width are available :
- 50 ms
- 100 ms
- 250 ms
CAUTION:
- Take care of witch energy meter runs (IN or OUT) (see p.15)
- If the chosen meter makes negatives increases (IN type), choose an negative increase
.
- If the chosen meter makes positives increases (OUT type), choose a positive increase.
To Next Page
