EasyManuals Logo

Argo ALICE 13 User Manual

Argo ALICE 13
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Service Manual
Maintenance
28
8.2 Clean and Maintenance
8.3 Check Before Use-season
Warning:
Check whether power plug and power socket are in good
condition.
Berore cleaning,turn off the dehumidifier and disconnect power.
Otherwise it may lead to electric shock.
Do not wash the dehumidifier with water,or it may lead to
electric shock.
Do not use volatile liquid(such as thinner or gasoline) to clean
dehumidifier.Otherwise it will damage units appearance.
1.
Grille and Case
To clean the case:When there is dust on the case, use soft
towel to dust it off; When the case is very dirty(greasy),use mild
detergent to clean it.To clean the grille:Use a dust catcher or
brush.
2.
Air Filter
least every 250 hours of operation or more often The air filter
should be checked and cleaned at if necessary.
After 250 hours of operation, the Clean the Filter indicator light
will glow to remind you to clean the filter. Remove the filter and
clean it. Replace the filter and press the Filter RESET pad to turn
off the Clean the Filter light.
To remove:
Press the two buttons, then pull out the filter.
To clean:
Clean the filter with warm, soapy water. Rinse and let the filter dry
before replacing it.
To install:
Put the filter back into the dehumidifier.
NOTE: DO NOT rinse or put the filter in an automatic
dishwasher.
Buttons
Check whether air fillter is clean.
Check whether drain hose is damaged.
8.4 Care After Use-season
Disconnect power.
Clean air filter and case.
Clean dust and obstacle of the dehumidifier.
Empty the water bucket.
8.5 Long-time Storage
If you wont use the dehumidifier for a long time,we suggest that you
follow the steps below in order to maintain the unit in good condition.
Make sure the bucket is clear of water and drain hose is removed.
Clean the unit and wrap it well to prevent the gathering of dust.
Bundle the tieline at the rear case. Use the tieline to collect the
power cord,if there is a clasp in the groove, put the power plug into
the clasp (As shown in fig.e). If there is no clasp in the groove, use
the tieline to collect the power cord and the power plug doesnt need
to be fixed by the clasp (As shown in fig.f).
Warning:
NOTE: Avoid using a dishwasher
to clean the filter.
Do not operate the dehumidifi without a fi er.Otherwise the
evaporator will catch dust and affect units performance.
Do not dry the air filter with fire or electric hair dryer.Otherwise
the air filter may be unshaped or caught on fire.
Dont use dust catcher or brush to clean the air filter.Otherwise
the air filter may be destroyed.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Argo ALICE 13 and is the answer not in the manual?

Argo ALICE 13 Specifications

General IconGeneral
Airflow115 m³/h
DisplayLED
Noise level43 dB
Product colorWhite
Built-in displayYes
Water tank capacity3 L
Suitable for room area up to15 m²
Suitable for room volume up to- m³
AC input voltage220 - 240 V
AC input frequency50 Hz
Power consumption (typical)220 W
Operating temperature (T-T)5 - 32 °C
Operating relative humidity (H-H)35 - 80 %
Weight and Dimensions IconWeight and Dimensions
Depth225 mm
Width353 mm
Height496 mm
Weight11500 g

Related product manuals