• Transversal, when the device is installed on a pole near the road and it has to be directed
toward the vehicles only by panning and tilting (approximately 2-5 meters from the edge of
the road and about 5-6 meters high). Typical field of application: fixed installation on a road.
In all the above geometries, different settings are required:
• Estimator Use a statistical model to estimate the best trigger position. Gives good results only
with the standard install geometry.
• ADJL, the angle correction value for leaving vehicles (see below).
• ADJO, the angle correction value for arriving vehicles (see below).
• Direction radar events can be filtered to detect only arriving or only leaving vehicles. Default is
no filter (Arriving and Leaving).
• Start offset, trigger start offset.
• End offset, trigger end offset.
• Trigger mode, trigger mode (edge, level, etc.).
To Next Page
Loading...
