ARIBEX Nomad Pro 2 - Settings Menu

23
Technique Factor time settings can be adjusted by the operator. This is done from the
main display screen by following these steps:
nPress the Increase or Decrease buttons until the desired time setting is
selected.
NOTE: When the Increase or Decrease buttons are pressed and held, the rate at
which the displayed time setting changes on screen accelerates.
oPress and release the Select button to activate the Save Menu.
pSelect Yes by pressing the Increase button.
qPress the Select button to select OK.
rOnce saved, this change will be maintained in memory until overwritten or until the
factory defaults are restored through the Reset Defaults menu item.
4.10 Settings Menu
The NOMAD Pro 2 menus allow the operator to customize settings according to individual
preferences. To access the Main Menu, press and hold down the Select
button for
three seconds. When the Main Menu appears, the operator can access the desired menu
item(s) by pressing the Increase
and Decrease buttons to scroll up or down. When
the desired menu item is highlighted, press the Select
button to access the menu item.
Within the menu items there are options (such as Yes and No) which are selected using
either the Increase
or Decrease buttons. Once a selection is made, pressing the
Select button confirms the choice.
To exit the Main Menu, highlight Exit at the bottom of the list and then press the Select
button, or power the device off and then on.
Menu Item Function
System Info
When system information is selected from the
settings menu, the device software version information
will be displayed on-screen. Pressing the Select button will
return the operator to the settings menu.
Audible Sound
The volume may be adjusted by the operator. The range is from one
(softest), up to five (loudest). The Increase
and Decrease
buttons are used to adjust the volume, and the system emits a tone
as each volume is selected so the operator can determine the choice.
Once the desired volume is determined, pressing the Select
button saves the volume setting.