Setting a cooking programme
with delayed start
Changing the cooking temperature
Press the button.
Adjust by pressing the + and – buttons.
Save your selection by pressing the “”button.
Changing the cooking time
During cooking, you can adjust the cooking time by
pressing and the + and - buttons.
Press START to start cooking.
Cancelling cooking in progress
You can stop the cooking at any time by pressing “” (for
approximately 1 second).
If steam generation has not yet begun (approximately one
minute), the oven stops immediately and the time display
disappears.
If steam generation has already begun, the time changes to
3 minutes, a countdown begins and the steam escapes
before the door is opened
.
Setting a cooking programme with delayed
start
Set the desired cooking mode, the time and adjust the
temperature if necessary,
Example: position Steam Cooking Temperature 85°C.
Press the button and select the cooking time using the
+ and - buttons, for example 30 min.
For example, it is 12:30.
You have programmed a 30-minute cooking cycle.
The displayed end of cooking time is 13:00.
Using the buttons, select end of cooking and the
end of cooking time is displayed.
Adjust the end time using the + and - buttons.
Example 14:00
Confirm by pressing “”to start the programme.
After these steps, oven heating is delayed so that cooking
ends at 14:00.
When the cooking cycle is finished, a series of beeps is
emitted for several minutes.
You can stop the beeps by pressing “”for one second.
You MUST empty the tank.
To ensure good oven reliability, the fan
continues to function for a short period after
cooking is complete.
At the end of cooking
In the event of a water circuit-related problem during cooking, the
“no water” indicator appears, a beep is emitted and a “Fill your
water tank” message appears in the display.
This error is specifically associated with:
- an empty tank.
- a poorly seated tank.
After checking these two points, close the door and press “”.
The oven restarts.
Water management
11
EN
To Next Page
Loading...
