3
EN
ELECTRICAL CONNECTION
Single-phase 20A Meter
220-240V
~
50 Hz
Electrical socket
2 pin + earth
to IEC 60083
standard
220-240 V
~
single-phase line
Power
supply cable
length 1.50 m
approx.
10A fuse or residual
current circuit breaker
The appliance must be fitted correctly to ensure electrical safety.
During fitting and maintenance operations, the appliance must be
unplugged from the electrical system; fuses must be switched off
or removed.
The electrical connections are made before the appliance is
installed in its housing.
Ensure that:
- the electrical installation has sufficient power,
- the electrical wires are in good condition,
- the diameter of the conductors complies with the requirements
of the installation.
Your oven must be connected with a (standardised) power cable
with three conductors of 1 mm² (1ph + 1N + earth) which must be
connected to a 220-240V
~
single-phase supply via a
1ph + 1 neutral + earth IEC 60083 standardised power socket or
via an all-pole cut-off device in compliance with installation rules.
Installing your appliance
Note
The safety wire (green-yellow) is connected to the
appliance’s terminal and must be connected to
the electrical installation’s earth system.
Where connected to a wall socket, the socket must
remain accessible after installation.
The circuit should be protected with a 10 Amp fuse.
If the power cable is damaged, it must be replaced by
the manufacturer, its After-Sales Service Department
or a similarly qualified person to prevent danger.
To Next Page
Loading...
