51
In-bed length
Position 1 (Short)
192cm
Position 2 (Standard)
203cm
Position 3 (Extended)
215cm
Overall width 103cm
Height of mattress platform (centre of seat section to floor)
With 125mm castors
32cm to 76cm
With 150mm castors
34cm to 78cm
Head down tilt angle 12° min.
Foot down tilt angle 12° min.
Mattress size (refer to Chapter 3 for details)
Position 2 (Standard)
202cm x 88cm, 12.5 to 18cm thick
Mattress platform angles
End of life disposal
x Equipment that has electrical and electronic components should be disassembled and
recycled per Waste of Electrical and Electronic Equipment (WEEE) or in accordance
with local or national regulation.
x All batteries in the product must be recycled separately. Batteries are to be disposed in
accordance with national or local regulations.
x Components that are primarily be made up of different kinds of metal (containing more
than 90% metal by weight) for example bed frame, should be recycled as metals.
Transportation and storage
Handle with care. Do not drop. Avoid shock or violent impact.
This equipment should be stored in a clean, dry and well-ventilated area which meets the
following conditions:
Temperature
-10qC to 50qC
Relative humidity
20% to 90% at 30qC, non-condensing
Atmospheric pressure 700hPa to 1060hPa
CAUTION
If the bed is stored for a long time, it should be connected to the electricity supply for
24 hours every three months to recharge the backup battery, otherwise it may become
unserviceable.
To Next Page
Loading...
