DIS-IP2 DESKTOP CALL STATION
USER MANUAL
page 8/37 armtel.com
© Armtel info@armtel.com
Table 2 - Main technical and operational characteristics of DIS-IP2 (end)
* Only for direct calls without using sound files (except for local sound files with a sampling
rate of 32 kHz (located in the local memory of the device) using the SIP protocol and when using
the SIP codec G.722.1
С.
When using the Armtel-IP protocol, the bandwidth is from 300 to 6800 Hz.
** Two Ethernet ports: "LINE" - is the main one, the second one is backup, including when
1.1.3 Design description
The enclosure and cover of DIS-IP2 are made of ABS gray color plastic RAL7035,
the cover has special form for better view of the pushbuttons. The external appearance
of DIS-IP2 with eight pushbuttons with the overalls and fully turned-up microphone
is shown in Figure 2.
The printed board is installed in the enclosure, containing the electronic components
necessary for DIS-IP2 functioning, as well as the modules:
− Wi-Fi module WM1123WU with antenna MaxLink 2,4/5GHz 5dBi Omni RP-
SMA (for all versions);
− modem ADSL Module IB02 v5.0 (for versions RMLT.465311.001-04…-07).
The enclosure is equipped with the rubber legs protruding from below, to make the
product steadier.
Each DIS-IP2 comprises the embedded software and configuration data, allowing it to
connect with other network subscribers directly, via wireless data transmission channel Wi-Fi or
using ADSL, as well as to control the communication and indication modes.
To Next Page
Loading...