DIS-IP2 DESKTOP CALL STATION
USER MANUAL
page 24/37 armtel.com
© Armtel info@armtel.com
3 PRODUCT MAINTENANCE
3.1 General
Maintenance shall be carried out in order to provide reliable operation and constant
readiness of the product for use.
The objects of maintenance are:
− DIS-IP2 Desktop call station;
− condition and connection of cables suitable for the product.
Maintenance is performed by DIS-IP2 service personnel.
Maintenance is performed once a year without switching the product off.
3.2 Safety precautions
The product provides safety for service personnel and meets the safety requirements
of Class III, set out in GOST IEC 61140-2012.
During maintenance, observe safety precautions according to “Occupation safe-
ty rules when operating electrical installation.
3.3 Product maintenance procedure
Maintenance includes the following activities:
− visual inspection of DIS-IP2 enclosure; there shall be no mechanical damages
(crack, dents, etc.) on its enclosure and pushbuttons; no fractures in the flexi-
ble part of microphone stand;
− visual inspection of the incoming cables to DIS-IP2 (no compressions and
damages of outer sheath);
− safety check of connection to the connectors on the cable - the cable shall
have no tension;
− cleaning of DIS-IP2 surface from dirt, using for this purpose the wet sponge
impregnated with mild soap solution or wet wipes for cleaning office appli-
ances ; the use of chemically active solvents is not admitted;
− perform diagnostics of DIS-IP2 operability according to 3.4.
The approximate time of DIS-IP2 maintenance is 30 minutes.
All the operations with the product, detected faults, as well as the negative results of
maintenance results should be registered in special logs.
To Next Page
Loading...