DIS-IP2 DESKTOP CALL STATION
USER MANUAL
armtel.com page 23/37
info@armtel.com © Armtel
Conference function is a two-way communication between subscribers, where each
Conference participator can transfer speech information to all remaining participators and
receive speech information simultaneously from all remaining participators.
The Conference organizer carries out Conference call. The Conference features are:
− all the Conference participators hear all the Conference participators;
− only the Conference organizer may invite and remove Conference participa-
tors;
− each Conference participator may leave the Conference independently;
− the Conference is in the general field of call priority.
The call of Conference participators is carried out by the Conference organizer, using
the DK with Conference function. After short-time pressing the DK with Conference func-
tion, the organizer consequently presses the direct call “Calling via SIP” pushbuttons of
subscribers to add new participators to the Conference.
The termination of Conference session is accomplished by the organizer, with press-
ing the DK Conference.
2.4.7.4 Relay function allows the product user to control the relay switch-on and
switch-off at the remote devices “АСМ-IP2 analogue subsystem module” RMLT.465275.006
and “АСМ-IP analogue subsystem module” ARMT.665230.134 manufactured by LLC
Armtel. The relay control is performed, using the DK Relay. In this mode, the control lines
on the ACM-IP2 are not activated, while the module is free for voice calls. The function
operates via Armtel-IP and SIP protocols.
To Next Page
Loading...