Safety Information
12
Always keep cables away from the product during
operation. Do not tilt the power cable directly after the
connector. Water could immerse and cause short cir-
cuits and damage the connector.
Disconnect all cables prior to transport.
Please observe the information given in the „Safety leaflet
ARRI lampheads“ (L5.40731.E). The leaflet is available for
download on our web site www.arri.com.
Replacing the Light Source
The light source contained in this luminaire shall only be re-
placed by the manufacturer or his service agent or a similar
qualified person.
Firmware Downgrade
Note: Please observe, that it is not possible to downgrade the
firmware to a version lower 1.0.0 after updating to version 1.0.0
or higher.
Maintenance Information
• Do not clean the surface of the product with solvents or strong
detergents.
• Clean the product with a soft cloth wetted with a mild deter-
gent. Do not rub the surface: lift stuck particles off with a soft
repeated press.
• Clean soiled electric contacts with cotton swabs wetted with
isopropyle alcohol.
• Keep electric contacts clean and replace corroded parts.
Intended use
This product is intended to illuminate persons and objects in a
dry environment.
Always follow the safety information.
Any usage other than described above is not permitted and can
damage the product and lead to associated risks such as short-
circuit, fire, electric shock, etc. You are not allowed to modify
the product.
This product fulfils European, national and international re-
quirements.
To Next Page
Loading...
Need help?
General
