EasyManuals Logo

ARRI SkyPanel User Manual

ARRI SkyPanel
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
RDM commands
44
Manufacturer commands
Lamp Hours Shows the actual lamp hours of the fixture X
Factory Defaults This command deletes all user parameters and sets the fixture to factory default X X
Device Power Cycles Shows the power cycle value, counts every cold start (switch or power-up) X
Reset Device Fixture makes a software reset (warm start) and carries out a reboot X X
Power State
Power state of the fixture, supported power states:
POWER_STATE_STANDBY (0x02),
POWER_STATE_NORMAL (0xFF),
POWER_STATE_FULL_OFF (0x00)
POWER_STATE_SHUTDOWN (0x01)
XX
Perform Selftest Supported test modes and demo modes X X
Self Test Description Shows a description for each test / demo mode X
Command Description GET SET
RDM Fan Mode
PID: 0x8001
Changes the FAN mode of the fixture
- this message supports Set and Get commands
- the first data byte is used to show / change the fan mode
USER_FAN_MODE_LOW = 1
USER_FAN_MODE_VARI = 2
USER_FAN_MODE_HIGH = 3
XX
RDM Status LED
PID: 0x8002
Switch on /off indication LEDs and LCD back light
- this message supports Set and Get commands
- the first data byte is used to switch indication LEDs on and off
LEDs and LCD back light on = 0
LEDs and LCD back light off = 1
XX
Command Description GET SET

Other manuals for ARRI SkyPanel

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ARRI SkyPanel and is the answer not in the manual?

ARRI SkyPanel Specifications

General IconGeneral
TypeLED Soft Light
Color Temperature2800K - 10000K
CRI≥ 95
Dimming0 - 100%
ControlDMX, Ethernet
Input Voltage100-240V AC, 50/60Hz

Related product manuals