EasyManua.ls Logo

Arris Touchstone TG4482 - Installation and Physical Connection

Arris Touchstone TG4482
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3
Install and connect your Telephony
Gateway
Before you start, make sure that:
You have contacted your service provider and verified that they provide data and
telephone service using standard DOCSIS technology.
You have all the Items you need (page 10).
Cable, phone, and power outlets are available near the computer. If a cable outlet is not
conveniently located, your service provider can install a new one.
If you have ordered service, your service provider should configure the Telephony Gateway
automatically. You need only follow the instructions in this section to install and connect the
Telephony Gateway.
CAUTION:
Risk of equipment damage.
Only qualified installation technicians should connect the Telephony Gateway to
house wiring. Incumbent telephone service must be physically disconnected at the
outside interface box before making any connections.
Front panel
The front of the TG4492 has the following indicators.
1. Status LED: Indicates the device power and status.
Touchstone TG4482 Telephony Gateway User Guide DRAFT Revision 1.3 16

Table of Contents