Arturia Keystep - Sequence Settings

64 ARTURIA – KeyStep – USER’S MANUAL
10.9.3 Sequence settings
Here’s a quick reference chart for those parameters:
Parameter
Range/Values
Description/Function
Sync Clock In/Out settings
1step (Gate/Clock),
1pulse, 24ppq, 48 ppq
Set Sync input/output type.
Refer to external device
documentation to determine
what the settings should be.
Sync Clock Start
On Clock, On Gate Start
Determines which sort of
signal will start KeyStep.
Next Seq
End, Instant Reset,
Instant Continue
Selects when the KeyStep
sequences will change and
whether they’ll start from
the top or the middle.
Transposition Input port
USB, MIDI, both
Sequences can be
transposed by external
devices. This decides which
ones are allowed to do so.
Transpose Input channel
1-16, all
Specifies the MIDI channel
to obey for transposition.
Transposition Latch
On, off
Decides whether a
sequence will only be
transposed while a key is
held down.
Transpose Center Pitch
Full MIDI note range
Notes above/below center
transpose the sequence
up/down
Velocity
As recorded, fixed
Disregard velocity or not
Fixed Velocity value
0-127
Set the preferred value
Tempo knob mode
Jump, pickup
Tempo can jump to knob
position or wait for passthru
Tap Tempo average
2, 3, or 4 taps
Number of taps to respond