Aruba Mobility Master - Installation; Precautions

Aruba Mobility Master Hardware Appliance | Installation Guide Installation | 13
Chapter 2
Installation
This chapter describes how to install an Aruba Mobility Master hardware appliance using the many
mounting options available. The Mobility Master hardware appliance ships with an accessory kit that
includes the equipment needed to install the appliance in standard, 19-inch telco rack.
 “Precautions” on page13
 “Selecting a Location” on page14
 “Rack Mounting- Standard” on page14
 “Rack Mount Installation- Mid” on page16
 “Table or Shelf Installation” on page17
 “Connecting and Disconnecting the AC Power Cord” on page18
 “Installing and Removing a Fan Module” on page18
 “Installing and Removing a Power Supply” on page19
 “Connecting and Removing an SFP/SFP+/LC Cable” on page20
Precautions
 Ensure that the rack is correctly and securely installed to prevent it from falling or becoming
unstable.
 Dangerous voltage above 240VAC is always present while the Aruba Power Supply Module is
plugged into an electrical outlet. Remove all rings, jewelry, and other potentially conductive
material before working with this device.
 Never insert foreign objects into the chassis, power supply, or any other component, even when
the power supply is turned Off, unplugged, or removed.
 Ensure that the main power is fully disconnected from the appliance by unplugging all power
cords from their outlets. For safety, verify that the power outlets and plugs are easily reachable by
the operator.
 Do not handle electrical cables which are not insulated. This also includes network cables.
 Keep water and other fluids away from the appliance to minimize electrical hazards.
 Comply with electrical grounding standards during all phases of installation and operation of the
product. Do not allow the appliance’s chassis, network ports, power supply, or mounting brackets
Installation of the device should be performed by a trained installation professional.
Please only use the included or Aruba specified cables, power cords, AC power supplies, and batteries. The
power cord should not be used with other electric equipment than what is specified by Aruba.
接続ケーブル、電源コード、AC アダプタ、バッテリーなどの部品は、必ず添付品または指定品をご使用ください。
また、電源ケーブルは弊社が指定する製品以外の電気機器には使用できないためご注意ください。