12
After successfully connected, the BT LED will stay on and you should be able to hear the sound coming
out from the connected Bluetooth device, and the connected output device will have no sound.
You can connect a second BT receiver device once the rst device has been successfully connected.
Press the Reset button on the back or press the BT TX button on the remote controller will trigger the
device to enter pairing mode for the second BT receiver device. The connection process is the same as
the rst device.
Connecting the second device will take 20 to 50 seconds, please be patient.
Once connected, both BT receiver device will have sound output.
To disconnect the Bluetooth connection, quickly press the Reset button twice to disconnect all the
connection.
7.2 Bluetooth Transmitter Mode
To enable Bluetooth transmitter mode, once you are in one of the source input modes (Line in / Phono in
/ Optical in / TV ARC / USB disk drive / USB DAC) press the Reset button on the back or press the BT
TX button on the remote controller to enable.
Once enabled, you will notice the BT LED will start flashing, the device will then search for nearby
Bluetooth receiver device (Bluetooth Speakers, headphones) and connect to it.
Please note, some BT receiver device might need you to enter pairing mode rst, some
BT receiver device might need to press a connection button to establish the connection.
Please refer to the device user manual or contact the seller for advice if needed.
To Next Page
Loading...
Need help?
General
