18
Connect the Up2Stream device to your PC with USB cable (make sure it’s a data cable including the signal
wires). And open the program ACPWorkbench (only support Windows.), and you can tune audio effects
conveniently, including Music Noise Suppressor, Virtual Bass, Stereo Widener, Exciter, 10 bands EQ,
Configure output channel and PIN configs. After editing the audio effects, you can save the changes to the
device so the tuned effects will remain. You can get more.
Connect the device to your PC with USB cable (make sure it’s a data cable including the signal wires). The
PC will automatically discover a USB sound card, and when you select it as the system main output, the PC
will send the audio output to the device in digital (44.1KHz/16bits). You can stream to other devices over
multiroom connection. NOTE: there’s about 3 seconds delay when in multiroom playback mode than the
audio source.
9.3 USB Audio
10. Up2Stream ACPWorkbench (Sell Separately)
To Next Page
Loading...
