ASCOM D42 User Manual

TD 93120EN
10 Oct 2016 / Ver. A
Configuration Manual
Ascom d43 DECT Handset
5
2. Getting Started with Configuration of the Handset
2.2.1 Via Chargers
1 Connect a DC4 desktop charger or a CR3 rack charger via the Ethernet port to the
network.
The charger is by default configured to connect to the network using DHCP. If DHCP is
not used in the network, connect each charger via USB to WinPDM and configure a
static IP address.
2 Open the Device Manager.
3 Place the handset in a charger that is connected to the Device Manager. The handset
can either be turned off or turned on when placing it in the charger. A handset that is
turned off starts up automatically and the battery charging symbol is displayed.
Figure 2. Configuration of handsets via Device Manager and chargers.
2.2.2 Over-the-air via IP-DECT
There is no external equipment needed besides Device Manager and IP-DECT. Please proceed
with 3. Handset Installation and Configuration on page 7.
Client
IP
Device Manager

ASCOM D42 Specifications

General

Brand	ASCOM
Model	D42
Category	Handsets
Language	English