50
2.4.1.2 LAN Settings
2.4.1.2.1 LAN
The LAN IP module allows administrator to modify lan-side IP address of the router.
Steps to modify the LAN IP settings:
1. From the navigation panel, go to Advanced > Network > LAN > LAN IP.
2. IP Address: The LAN IP address of wireless router. The default value is
192.168.1.1. In IP-based networks, data packets are sent to the network devices'
specific IP addresses.
3. Subnet Mask: The LAN subnet mask of wireless router. Its default value is
255.255.255.0
4. Click Apply.
NOTE: Any change to the LAN IP module will affect router’s DHCP settings.
To Next Page
