27
END OF PROGRAMME
When the cool-down period has ended, the drying process is finished, and the
display shows the text
“end” (flashing).
When the START/STOP button is then pressed, the current programme ends and
the display shows the last used programme.
ENDING DRYING PROGRAMME
To interrupt a drying process in progress, press START/STOP.
DOOR OPENED
If the door is opened while the drying process is in progress, the drying process
will continue for another 5 minutes. The display shows
“close door” and counts
down the 5 minute programme pause period.
If the door is closed within this 5 minute period, the drying process will continue.
If the door is left open, the drying process will stop after 5 minutes and must be
restarted manually.
If you wish to stop the drying process immediately, without a 5 minute period, press
START/STOP.
_____________________________
NB
In standby mode the display goes off after
10 minutes and lights up when any of the
buttons on the control panel is activated
or the door is opened.
____________________________________
____________________________
NB
Empty the condensation water tank after
each drying process.
___________________________________
To Next Page
Loading...
