35
LIST OF ERROR CODES
No. Name Description
ERROR 03 Fault on moisture sensor Sensor is outside its measurement
range
Contact Service.
ERROR 04 Max time process Max time for drying process exceeded
(pre-set value 240 min can be
changed with parameter P 2073).
ERROR 06 Check water pump Water level in tray too high, has
activated switch at float.
Contact Service.
ERROR 12 Timeout communication The communication between user
interface and electronics has been
temporarily interrupted.
Contact Service.
To reset the alarm, hold down the START/STOP
button for 5 sec.
Describes relevant error codes for this product.
To Next Page
Loading...
