Asko DC7784HP - SETTING OF DRYING PROGRAMME; Programme Optimization Introduction

28
SETTING OF DRYING PROGRAMME
There are ways of optimising the two automatic programmes of the drying cabinet for
best possible results.
The setting is adjusted on the control panel for the programme concerned.
Adjustments must be made if it is found that the
 Washing does not dry sufficiently.
 Washing is over-dried – Long drying time.
INTRODUCTION
The drying cabinet's two automatic programmes stop automatically when the laundry
is dry. To decide when the washing is dry, a measured value is compared against a
factory-set parameter.
 Parameter P 2072 for NORMAL DRY drying programme and
 Parameter P 2071 for EXTRA DRY drying programme.
It is primarily these two parameters that are adjusted to optimise the drying process.
 The NORMAL DRY programme is controlled by a moisture sensor.
 EXTRA DRY programme is controlled by a moisture sensor and a time factor.
 If it is found that the washing does not dry sufficiently in the:
NORMAL DRY drying programme, the parameter value for P 2072 is reduced.
EXTRA DRY drying programme, the parameter value for P 2071 is increased.
 If it is found that the washing is over-dried, long drying time in the:
NORMAL DRY drying programme, the parameter value for P 2072 is increased.
EXTRA DRY drying programme, the parameter value for P 2071 is reduced.
Drying processes must always be optimised in small steps; start by adjusting the param-
eter concerned 1-2 units up or down, then check the result after the next drying process
and make a further adjustment if necessary.