ASL INTERCOM RRM02 - Configuring Router Contact for Routing; Obtaining the Router Contact Number

RRM02 - Product Manual
Issue: 02 complete, approved
Page 46 of 68
6.2.1.2.2 Obtaining the Router Contact Number
Check the system design documentation to find the Router contact(s) number being used by each RRM02.
Note that you will also need the microphone input used by the RRM02 unit controlled by each contact.
6.2.1.2.3 Configuring Router Contact for Routing
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆContactsÆ<Contact #nn>ÆRouting
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆContacts
Æ<Digital #nn>ÆRouting
Where nn is the Router contact number found in Section “6.2.1.2.2 Obtaining the Router Contact Number”
(page 46).
Once a contact is configured for ‘Routing’, it is necessary to define the route(s) that it controls, and to set the
routing control parameters as described in the following steps.
1. Configure the route(s) by associating the microphone input used by the relevant RRM02 to each
output found in Section “6.2.1.2.1 Obtaining the Router Output Number” (page 45).
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆContacts
Æ<Contact #nn>ÆRoutingÆZoning
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆContacts
Æ<Digital #nn>ÆRoutingÆZoning
2. Configure the route(s) for non-latching operation, i.e., the activation of the contact initiates the route.
When the contact is released, the route is cleared.
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆContacts
Æ<Contact #nn>ÆRoutingÆControlÆLatchingÆNot-Latched
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆContacts
Æ<Digital #nn>ÆRoutingÆControlÆLatchingÆNot-Latched
3. Configure the route(s) to be terminated immediately when the contact is released.
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆContacts
Æ<Contact #nn>ÆRoutingÆControlÆDVA-Part
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆContacts
Æ<Digital #nn>ÆRoutingÆControlÆDVA-Part
4. Configure the route(s) to cause busy indication on LEDs associated with microphone zone select
buttons.
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆContacts
Æ<Contact #nn>ÆRoutingÆControlÆBusy=On
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆContacts
Æ<Digital #nn>ÆRoutingÆControlÆBusy=On