ASL INTERCOM RRM02 - Configuring Bmb01 S Digital Output for Busy Indication; For Connection to Other PA Systems

RRM02 - Product Manual
Issue: 02 complete, approved
Page 51 of 68
3. Configure the route(s) to be terminated immediately when the contact is released.
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆRemote
Æ<Remote I/O Unit=n>ÆDigital InÆ<Contact #ii>ÆRoutingÆControlÆDVA-Part
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆRemote
Æ<Unit Address #n>ÆDigital InÆ<Æ<Digital #ii>ÆRoutingÆControlÆDVA-Part
4. Configure the route(s) to cause busy indication on LEDs associated with microphone zone select
buttons.
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆRemote
Æ<Remote I/O Unit=n>ÆDigital InÆ<Contact #ii>ÆRoutingÆControlÆBusy=On
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆRemote
Æ<Unit Address #n>ÆDigital InÆ<Æ<Digital #ii>ÆRoutingÆControlÆBusy=On
6.2.2.4.6 Configuring BMB01’s Digital Output for Busy Indication
VAR4/12/20 Menu: ConfigurationÆSystemÆRouterÆControlÆRemote
Æ<Remote I/O Unit=n>ÆDigital OutÆ<Output #ii>ÆBusy-Indication
DAU/ACU/VAR8/VAR8-ACU Menu: ConfigurationÆSystemÆRouterÆCtrlÆRemote
Æ<Unit Address #n>ÆDigital OutÆ<Æ<Digital #ii>ÆBusy-Indication
Where n is the BMB01 unit address, and ii is the BMB01 digital output number found in Section “6.2.2.4.4
Obtaining the BMB01 Digital Output Number” (page 50).
Select the Router inputs connected to the RRM02 units to cause Busy Indication when routed to the
intermediate output found in Section “6.2.2.2.1 Obtaining the Router Intermediate Output Number” (page 48).
6.3 For Connection to Other PA Systems
Commissioning of the RRM02 depends on the PA system which the RRM02 is connected to, therefore
consult your PA system relevant documentation for details.