ASM Zip-Spray ESP - Page 18

Shutdown and Cleaning
18 311139B
13. Fill unit with Pump Defender
™
storage fluid. Read Long Term
Storage, page 21.
Zip-Flush Cleaning
Zip-Flush cleaning is a faster method of flushing com-
pared to pail flushing. It can only be used after spraying
water-based coatings.
1. Turn power switch OFF. Lift suction tube and prime
tube from paint pail. Let them drain into paint for a
while.
2. Place suction and prime tube in waste pail.
3. Turn Spray-Prime/Drain Valve
to PRIME.
4. Turn Pressure Control knob
to the left (counter-clock-
wise) to minimum pressure.
5. Trigger gun into waste pail to relieve pressure in
hose.
6. Remove tip and guard assembly from gun and place
in flushing fluid.
7. Screw Zip-Flush attachment to garden hose. Open
valve.
8. Turn on water. Rinse paint off suction tube, prime
tube and inlet screen.
9. Turn lever to close Zip-Flush
attachment.
10. Unscrew inlet screen from suc-
tion tube. Place inlet screen in waste
pail.
11. Connect garden hose to suction tube
with Zip-Flush attachment. Leave
prime tube in waste pail.
12. Turn Spray-Prime/Drain valve to
SPRAY.
• To avoid fluid splashing back on your skin or into
your eyes, always aim gun at inside wall of pail.
TIA
Pump Defender.
35,0(
WLD
WLD
)/86+,1*
)/8,'
TIA
CLOSED
WLD
WLD
302!9
TIA