Sicherheitsbeschlag mit integrierter Zutrittskontrolle
Seite 58 D0044508
2.7.2 Cancelling all user fingers
Notice
In this operation all user fingers are cancelled. The master fingers and the cancel fingers remain stored.
In order to be able to operate the fitting you must read in a new user finger and if applicable a new
substitute user finger.
1. Start the programming:
" &' &'
beep……… flashing
Draw your master finger over the sensor
You will hear an audible signal.
and flashing alternately for a few seconds.
" &' &'
beep……… flashing
Draw your master finger over the sensor again.
You will hear an audible signal.
and flashing alternately for a few seconds.
2. Carry out cancellation operation:
" &+'
beep flashes 4x
Draw the cancel finger over the sensor.
You will hear an audible signal.
flashes 4 times.
Q All user fingers are cancelled.
Q The cancel fingers and master fingers remain stored.
To Next Page
Loading...
