Sicherheitsbeschlag mit integrierter Zutrittskontrolle
Seite 50 D0044508
2.4 Step 1: Read in the master finger:
The first finger that you read in after the installation of the fitting automatically becomes the master finger.
Notice
The external door handle must be activated.
1. Start the programming:
" &' &'
beep……… flashing
Draw your master finger over the sensor
You will hear an audible signal.
and flashing alternately for a few seconds.
" &'
beep lights up flashes
Draw your master finger over the sensor
You will hear an audible signal.
lights up.
flashes.
2. Read in the master finger:
" &'
beep lights up flashes
Draw your master finger over the sensor
You will hear an audible signal.
lights up.
flashes.
" &'
beep lights up flashes
Draw your master finger over the sensor
You will hear an audible signal.
lights up.
flashes.
" &'
beep lights up flashes
Draw your master finger over the sensor
You will hear an audible signal.
lights up.
flashes for about 15 sec.
Whilst flashes you must read in the substitute master finger.
Caution
If you now terminate the programming process, the master finger remains saved.
No substitute master finger is stored.
To Next Page
Loading...
