Assa Abloy ANYKEY - Step 2: Registering the Cancel Finger; Initiating Cancel Finger Programming; Reading the Primary Cancel Finger; Cancel Finger Programming Note

Sicherheitsbeschlag mit integrierter Zutrittskontrolle
Seite 52 D0044508
2.5 Step 2: Reading in the cancel finger
The next finger that you read in after the installation and after reading in the master finger automatically becomes
the cancel finger.
1. Start the programming:

" &' &'
beep……… flashing
Draw your master finger over the sensor
You will hear an audible signal.
 and  flashing alternately for a few seconds.
2. Read in cancel finger:

"  &'
beep lights up flashes
Draw the cancel finger over the sensor.
You will hear an audible signal.
 lights up.
 flashes.

"  &'
beep lights up flashes
Draw the cancel finger over the sensor.
You will hear an audible signal.
 lights up.
 flashes.

"  &'
beep lights up flashes
Draw the cancel finger over the sensor.
You will hear an audible signal.
 lights up.
 flashes.
Whilst  flashes you must read in the substitute cancel finger.
Caution
If you now terminate the programming process, the cancel finger remains saved.
No substitute cancel finger is stored.