1-800-810-WIRE • www.sargentlock.com • A8190B 11
Copyright © 2016, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
IN100 Mortise Lock
Inside of DoorOutside of Door
DPS
Fig. 7B
Fig. 7A
7 Assemble Outside Trim
1. With outside lever horizontal (and handle pointing toward door hinge), insert the mounting posts through
outside of door and lock body.
Make certain the lever spindle is properly engaged inside the lock body (Fig 7A).
2. On the inside of the door, insert spindle into square hole of mortise lock, with spindle slot directed away
from the mortise lock body, and aligned with the set screw hole in the Inside adapter (Fig 7B).
3. Slide inside adapter and plate assembly over spindle and secure with (2) 8-32 X 5/8” Phillips
oval head and lock washer machine screws.
Note: Ensure that position of set screw hole on inside adapter is oriented to match location of hole in
inside lever handle.
Wire Harness
(From Lock Body)
Spindle
Outside Trim
Spindle
Fig. 7A Detail
Outside Trim
Set Screw Hole
Ground Wire
To Next Page
Loading...
